Do GLSL subroutines cause any performance overhead?
There's not too much deep information about them on the web.
How are they implemented and how they work under the hood? I'd like to know that they cause any performance overhead or not, especially in the case of multiple subroutines to decide what's the best practice to create different versions of shaders: subroutines or separate shaders.
Any info or advice?
Last edited by plasmacel; 07-17-2013 at 04:15 PM.
Subroutine variables are pretty much like function pointers in C, or if we have to, we can call them "virtual functions" (as D3D refers to them).
They are probably implemented on all hardware as actual function pointers, i.e. calling a subroutine will translate to an indirect CALL instruction that takes the called address from a register/memory location.
Thus you can expect them to likely be more efficient than switch case statements in shaders or switching between multiple shaders.
However, this is all just how it should work, as there could be inefficiencies in some hardware or driver that make them slower than they could be, but that's another story. Also, unfortunately, subroutines have an inherent inefficiency due to the API itself, namely that you have to re-specify the association between subroutine variables and subroutines (using glUniformSubroutinesuiv) every single time you bind a program that has subroutine variables. This is an unfortunate inheritance from D3D, as GL copied this weird behavior from there.
Disclaimer: This is my personal profile. Whatever I write here is my personal opinion and none of my statements or speculations are anyhow related to my employer and as such should not be treated as accurate or valid and in no case should those be considered to represent the opinions of my employer.
Technical Blog: http://www.rastergrid.com/blog/
So subroutine variables perform better than shader swapping, recompiling or in-shader "if conditional" multifunctionality.
However in the aspect of the performance of a single shader it's better without them.
Greetings from Hungary by the way ;]
Last edited by plasmacel; 07-17-2013 at 03:52 PM.
in-shader "if conditional"
I have found for a small set if tests (2-3) the if test is quicker to using subroutines; but there are good reasons for using them in complex shaders as they can make them a lot easier to expand functionality.