PDA

View Full Version : Ability to Trim a Cone



12-04-2000, 06:47 AM
I would like to create a cone that does not have a radius of 0 at the smaller end of the cone. Or in other words, I want to draw a true cone, and trim off the part that I do not need. So the end product would be a circle with radius of ten inches connected to another circle of radius 8 inches, with the tapered walls between the two. Any help would be much appreciative.

Wil

jc
12-04-2000, 07:08 AM
u can use glutsolidcone, i think tha parameters are the small and big radius ... but i'm not sure (can't have glut specifications)