hi,
I get some artifacts along the edges from my cube when it rotates. Is it a problem with the Z-Buffer ?
If you want to help me … thanks
topSurfeur
hi,
I get some artifacts along the edges from my cube when it rotates. Is it a problem with the Z-Buffer ?
If you want to help me … thanks
topSurfeur
You need to better describe the artifacts before a diagnosis and remedy can be given. However from past experience, whenever someone has asked about artifacts, the problem indeed is usually related to the z-buffer almost all the time. But exactly what is wrong may still vary, though again, the most common z artifact for beginners is an improper zNear to zFar ratio, either they have set zNear to 0, or set zFar to be much too big.
[This message has been edited by DFrey (edited 09-02-2001).]
thanks for your help DFrey
topSurfeur