View Full Version : MOHAA Voodoo2 sli
03-10-2002, 11:32 PM
ok everyones asked for a solution and I need one too, amd running W98SE celeron 733,198 mb directx 8.1. The problem I have is that I'm running a S3 Trio 3D/2X AGP card and my main 3D cards are 2 12 mb voodoo2's scanline interleaved, so for some reason when I try to run it the monitor switches off. There must be someway to tell MOHAA that my preferred card is the voodoo.
Please help me lol
This information is directly from the README.TXT included in your directory for the game on your hard drive and should answer your question.
The following 16MB or greater 3D accelerators are not fully
supported and do not work properly with the game:
-3Dfx Voodoo 4 and 5
No intro movies play. Various textures are corrupted.
Breakable windows are opaque until broken. Once
broken they have a corrupted texture.
-3Dfx Voodoo 3
Various textures are corrupted. Breakable windows are
opaque until broken. Once broken they have a corrupted
texture. Transparent red bomb placements are invisible.
-3Dfx Voodoo Banshee cards
-Matrox G400 and G450
Frame rate is often below 10 frames per second even at
the lowest video settings. Level load times are longer
These older cards yield a frame rate that is often
below 10 frames per second even at the lowest video
-PowerVR NEON 250 cards:
Video Logic PowerVR Neon 250
-S3 Savage 2000 cards:
Diamond Viper II
-S3 Savage 4 cards:
Diamond Stealth III S540
Diamond Stealth III S540 Extreme
-SiS 300 cards
Remember always read the help files and last but not least the README.TXT before installing the game. Like it says the file contains info that didnt make it into the manual. Hope it helps.
Powered by vBulletin® Version 4.2.0 Copyright © 2013 vBulletin Solutions, Inc. All rights reserved.